If you have a basement in your home, you may be familiar with some of the issues that come from that part of your house — mostly, the fact that it’s vulnerable to high water.
Basements are below-floor elevation and lower than the yard, which is what causes bulk water to run off the roof, down the gutter, and into the basement. There is a way to solve this – by installing a sump pump.
We’re here to help you out with that project. Read on to learn how to install a sump pump.
Drilling the Hole for the Sump Pump
Find the correct location for the hole. The hole needs to be big enough for the pump to fit snugly, so make sure to measure the pump before drilling. Use a drill bit that is slightly larger than the pump to create the hole.
Be sure to wear safety glasses and a dust mask while drilling. Next, clean up any debris and test the fit of the pump. If all goes well, the sump pump is ready to be installed.
Installing the Sump Pump
A sump pump is a basement pump device that is used to wash away water that has been stored in a sump pit to avoid moisture in crawl space. The sump pump removes water from the pit and pumps it out of the basement.
Installing a sump pump is a relatively easy task that can be completed in a few hours. Find the location of the sump pit after the drilling process then install the pump into the pit.
Making the Connections
Installing the sump pump connections is a simple process that anyone can do.
First, you need to locate the main water line coming into your home. Once you have located the main water line, you need to find the shut-off valve for the line and turn it off.
Next, you need to find the sump pit. The sump pit is usually located in the lowest area of the basement. Finally, you need to connect the discharge hose to the sump pump and connect the other end of the hose to the main water line.
Back-filling and Caulking
If your sump pump has been installed, back-filling and caulking are two additional steps that should be completed to help ensure that your pump will function properly.
Back-filling is the process of filling the void around the pump with gravel or soil. This helps to support the pump and keep it from moving around.
Caulking is used to seal any gaps or cracks around the pump. This helps to prevent water from seeping in and damaging the pump.
Testing the Sump Pump
To test the sump pump, fill the pit with water and watch the pump to see if it comes on. If it does, let it run for a few minutes to make sure it’s working properly.
You can also check the discharge pipe to make sure water is being pumped out of the pit. If everything looks good, then your sump pump is working properly.
Get Some Bulk Water Basement Plumbing Help
If you have a wet basement, installing a sump pump is a great way to get rid of bulk water. This project is relatively easy to do and can be completed in a few hours. However, if you are not sure of what to do, simply call a professional.